When a fault message is applied, an alarm signal, a flashing signal and a horn relay are activated. The horn relay can be switched off by means of the incorporated pushbutton or an externally applied signal. An active alarm signal is shown as long as it is applied.
- acknowledgeable horn output
- Connection with screw-type terminals
Resources
Specifications
General Data | Operating voltage | 24 V AC/DC, 230 V AC |
| Current consumption | less than 60 mA |
| Output / contact | 3 relay outputs |
| Output / contact material | AgSnO2 |
| Output / switching voltage | 250 V |
| Output / continuous current | 4 A |
| Output / switching frequency | 360 cycles/h |
| Mechanical endurance | 1 x 107 switching cycles |
| Electrical endurance | 1 x 105switching cycles |
| Cross-section | 2.5 mm2 |
| Display | Yellow LED |
| Dimensions (W x H x D) | 35 x 69.3 x 60 mm |
| Weight | 70 g |
| Operating temperature range | 0 °C to 55 °C |
| Storage temperature range | -25 °C to 70 °C |
| Ingress protection for housing / terminal block | IP40 / IP20 |
