CAN module with 4 analog outputs. It is suitable as encoder for control variables, for example for electrical vent and mixing valves, valve positions, etc. The fieldbus module is an output module for universal use. It is controlled by means of the CAN bus. The module is addressed by means of an adjustable address, and the output states are transmitted in data bytes. If there is an analog input module with the same address in the system, the voltage measured there is issued at the respective output.
- Connection with screw type terminal blocks
Resources
Specifications
General Data | Protocol | CAN |
| Addressing range | 00 to 99 |
| Bus interface ©CiA standard | 2.0B passive (two-wire bus) |
| Transmission rate | 20 to 500 kBit/s |
| Operating voltage | 24 V AC/DC +/- 10 % (SELV) |
| Current consumption | 90 mA (AC) / 32 mA (DC) |
| Relative duty cycle | 100 % |
| Recovery time | 550 ms |
| Outputs | 4 x analog |
| Output / voltage | 0 V to 10 V DC |
| Output / current | 5 mA at 10 V DC |
| Output / resolution | 10 mV/digit |
| Output / switching voltage | +/- 1 % |
| Display | Green and red LED |
| Dimensions (W x H x D) | 35 x 69.3 x 60 mm |
| Weight | 84 g |
| Operating temperature range | -5 °C to 55 °C |
| Storage temperature range | -20 °C to 70 °C |
| Ingress protection for housing / terminal block | IP40 / IP20 |
