Series 220 solenoid valve connectors have a low housing and comply with design B DIN EN 175301-803. In addition to the DIN standard, the industrial standard is also offered. These connectors with 2+PE contacts are available pre-assembled and PUR moulded (IP67) or as self-terminating variants with screw terminal connections. The series is complemented by device connectors, as well as flat and profile seals to increase the degree of protection. If an optical status display is also required, the available LED versions can be used.
General Features| Part no. | 43 1801 000 03 |
|---|
| Connector design | Male power connector |
|---|
| Version | Connector pin straight |
|---|
| Connector locking system | Central bolt |
|---|
| Termination | solder |
|---|
| Degree of protection | IP40 without seal
IP65 with seal, see accessories |
|---|
| Cross-sectional area | 1.00 mm² / AWG 17 |
|---|
| Temperature range from/to | -25 °C / 100 °C |
|---|
| Mechanical operation | > 50 Mating cycles |
|---|
| Weight (g) | 7.48 |
|---|
| Customs tariff number | 85369010 |
|---|
Electrical Parameters| Rated voltage | 250 V |
|---|
| Rated impulse voltage | 4000 V |
|---|
| Rated current (40 °C) | 10.0 A |
|---|
| Insulation resistance | ? 10¹? ? |
|---|
| Pollution degree | 3 |
|---|
| Overvoltage category | III |
|---|
| Insulating material group | III |
|---|
| EMC compliance | unshielded |
|---|
Material| Contact body material | PA (UL94 HB) |
|---|
| Contact material | CuZn (brass) |
|---|
| Contact plating | Sn (tin) |
|---|
| REACH SVHC | CAS 7439-92-1 (Lead)
|
|---|
| SCIP number | SCIP-number not available |
|---|
Declarations of conformity| Low Voltage Directive | 2014/35/EU (EN 60204-1:2018;EN 60529:1991) |
|---|
